Please allow 4-5 weeks for estimate appts due to high call volume. We are worth the wait!!!!

Click here to learn more.

Finishing a Basement in Wisconsin

Top Ten Tips for preparing your basement for Remodeling

Badger Basement Systems has seen thousands of finished and unfinished basements with water problems ranging from dampness to all-out flooding in Wisconsin and Illinois. If you are going to finish your basement, this is what we recommend to prepare it properly. If you already have finished your basement, the majority of these precautions can still be made.

WaterGuard® Basement Waterproofing System

1. Install an Effective Waterproofing System

If you've had any evidence of groundwater seepage or currently get water in the basement when it rains in Wisconsin or Illinois, then it needs a quality basement waterproofing system like WaterGuard®, DryTrak® or other options available from Basement Systems. Basement water problems never get better, they only get worse as the house ages and the drains and coatings that protected the house fail. Therefore, even if water seepage is a once-a-year occurrence, it needs to be fixed before the basement is finished, as flooding is likely to be more frequent in the future. Some cautious homeowners put in such a system even if they have not had seepage, just in case. This makes sense from the standpoint that these systems are far easier to put in a basement that is unfinished than one where finished walls and floor coverings restrict access afterward. It is also highly recommended that this system be installed around the entire perimeter of the basement.

TripleSafe Sump Pump Installation in Wisconsin

2. Install a Reliable Sump Pump with Alarm and Back-up Systems

Before investing in finishing your basement, you should have the best sump pump protection available to guard your home against flooding from primary pump failure, pump overload from torrential rains, and power failure. Badger Basement Systems installs the TripleSafe sump pump system stands ready with primary and secondary AC-powered pumps and a third battery-operated backup pump in a single airtight sump liner. The TripleSafe system automatically pumps out water in the event that the power goes out or the primary pump mechanically fails to operate. Without this triple protection, your finished basement is only one pump or power failure away from a flood. Ensure a dry basement all the time with triple protection — before you invest in it.

If you do not have a TripleSafe pump system and have a Basement Systems' SuperSump® instead, at the very minimum you should have an UltraSump® backup pumping system and a WaterWatch® Alarm. The UltraSump® (standard with a TripleSafe system) is a battery-operated backup pumping system with a DC pump installed in the same sump hole, a battery, and a charging system. The UltraSump® will pump up to 7000 gallons of water out of your basement in the event of the primary pump failing for any reason including power outages. A WaterWatch® Alarm is standard on all Basement Systems pump systems and will sound off to alert you to pump failure before your floor gets wet.

IceGuard® Sump Pump Discharge Line

3. Guard Against Floods from Frozen Sump Discharge Lines

Snow and ice can block the opening of your sump pump discharge line and cause it to freeze. When this happens the water from your sump will not be able to get out, causing a potential flooding situation.

Basement Systems IceGuard, which is standard on most systems, will prevent this problem automatically.

4. Install a vapor barrier on the walls before you put up finished walls

ThermalDry® Wall System - Vapor Barrier Water vapor can pass through basement walls and contribute to a higher humidity level in the basement. Installing a sheet of plastic, preferably a high-quality, extra-durable one will direct water seepage down to the drainage system below and keep it off of the studs and sheetrock or paneling. It will also keep water vapor from getting into the basement environment and lower the humidity levels. It is important that the vapor barrier be tucked into the drainage system below if one exists. The top of the vapor barrier should be caulked to the top of the wall. Even better, you can install a vapor-proof drainage sheet on the walls that will insulate, such as Basement Systems' ThermalDry® WALL System, which reflects 97% of the heat back into your basement saving you money on energy bills and creating a drier environment.

ThermalDry® Floor Matting in Wisconsin

5. Keep the floor warm, dry and comfortable

After addressing any possible leakage problems in the basement, the next thing to eliminate is water vapor from coming through the concrete floor. Because concrete is porous, water vapor will slowly and continuously travel up through it. If you lay a carpet on top of the concrete floor, this moisture gets trapped under the carpet and causes odors, mold and rot in the carpet. Basement Systems' solution is a ThermalDry® Basement Floor Matting system. The tiling system consists of a specially engineered polypropylene, 17-inch tongue-&-groove square tile that, unlike systems that use wood, is totally water and vapor proof and will not inhibit mold. The unique grid design on the bottom of the tile creates an air space that insulates the floor and does not cause water vapor to condense. The installation takes away only 3/8'' of precious ceiling height in the basement, instead of 4'' for other methods.

FloodRing® Water Heater Flood Protection

6. Protect against common plumbing leaks that ruin your finished basement

Any water leakage, whether it is from the ground or not, will have the same damaging effect on your finished basement. Basement Systems has easy solutions for the two most common domestic water leaks, which we see all the time:

Water Heater Leaks: The average life of a water heater is seven years, and when they fail, they usually leak and flood the basement. Basement Systems FloodRing® is the solution. The FloodRing® will contain water seepage and drain it to the waterproofing system when the water heater leaks.

EverLast™ Basement Windows

7. Inspect your basement windows

Will you be happy with your old windows in your newly finished basement? Basement windows are notorious for being hard to open and drafty. Furthermore, the wet environment near the ground or in a window well causes a metal frame to rust and a wood window to rot. Many do not have screens and painting them is a constant challenge.

Badger Basement Systems can replace your EverLast™ Windows. They feature smooth sliding operation, double glass, full screen, easily removable panes for cleaning or passing long objects into the basement, and they never need to be painted! The best time to replace your basement windows is before you finish the basement. Then the carpenters can trim right up to them for a nice finished look.

SaniDry™ Basement dehumidifier

8. Dehumidify the space

Most conventional dehumidifiers are too small to do an effective job. The SaniDry™ Basement Air System is a powerful and effective dehumidifier. The SaniDry™ dries the air and automatically drains the water out of the hose, so you never have to empty it, like a conventional dehumidifier.

The SaniDry™ takes three times the amount of water out of the air as a typical dehumidifier, yet uses the same energy. The SaniDry™ has a powerful blower to draw musty air in and move the dry, clean air back out into the basement. This unit helps to ensure that you won't have high humidity and musty smells in your finished basement.

9. Install Emergency Exit Windows

Badger Basement Systems uses ScapeWEL windows, which adds safe emergency exit to finished rooms. In addition to offering easy escape if an emergency calls, ScapeWEL window wells will add light and ventilation to your lower level living areas, making them as warm and comfortable as any other room in the home.

 

RainChute® Downspout Extension

10. Perform some basic exterior maintenance

You should have your downspouts extended with Basement Systems' RainChute® to keep roof water away from the foundation. Keep the soil graded away from the house wherever possible, and keep the gutters clean. Keep window wells clear of leaves and debris.

Looking for a price? Get a no cost, no obligation free estimate.

our service area

We serve the following areas

Our Locations:

Badger Basement Systems
N1656 Hwy 12S
P.O. Box 158
Fort Atkinson, WI 53538
1-920-278-5832